I am running into wall after wall with both Cisco and Solarwinds support. It sounds like the packet capture on the ORION server is showing that I am missing a "valid interface index" under the flow record template in the ASR. I can't find what that commnand would be. Here is my current config on that ASR920. Support also saying that I am missing: "OUTPUT_SNMP" or "OutputInt:_ " - not sure what this translates to as far as a Cisco command to put under the flow record. Dang, why does this have to be so confusing? Thanks for any suggestions everyone!
flow record R1
match ipv4 protocol
match ipv4 destination address
match transport source-port
match transport destination-port
match interface input
match ipv4 source address
match ipv4 tos
collect counter packets long
collect counter bytes long
!
!
flow exporter E1
destination 164.110.x.x
source Loopback0
transport udp 2055
template data timeout 60
!
!
flow monitor M1
description flows to ORION
exporter E1
cache timeout inactive 10
cache timeout active 5
record R1
license udi pid ASR-920-12CZ-A sn CAT2044U3JR
license accept end user agreement
license boot level advancedmetroipaccess
!
sdm prefer netflow-video
interface GigabitEthernet0/0/0
description Fiber link to HQ Maple Park ASR HQMPPK100203 G0/1/1
ip address 10.88.x.x
ip flow monitor M1 input
negotiation auto
cdp enable
interface Loopback0
ip address 10.154.x.x
